Airone PX01 Incab Kit Airbag Inflation Kit PX01 Incab Airbag control Simple installation

Content : Brand New Airone Airbag Inflation Kit PX01 Incab Airbag control

Includes :

1 x PX-01 12V Air Compressor
1 x Stamped stainless steel gauge panel
2 x Pneumatic Push Buttons for dropping each bag
1 x 12V momentary switch for compressor
1 x BOSS 200psi Dual Needle back-lit Gauge
10 meters of 1/4" J844 DOT Airbrake line
1 x 1/4" push connect Y check valve
4 x Y Connectors
2 x T Connectors
4 x 1/4" female push fittings for gauge and buttons
10 x Cable Ties
Instruction Sheet

Specifications

This kit is used to control Airone Load Assist Kits or airbag suspension from inside your cab without the need for a tank and electric valves.Simple installation with control of airbags independently up and down using our PX01 compressor

Airone - Performance Suspension

To get the best performance from your kit inflate airbags just enough to achieve a level ride height.

By doing this you are also allowing all of the suspension components to share the extra load of the vehicle and not putting any unecessary pressure on any one individual part of your vehicles suspension.